How do I change a fuel pump on a 1999 ford explorer?

i have a little bit of car knowledge, should i even attempt it, or just have a pro do it?
How do I change a fuel pump on a 1999 ford explorer?
The fuel tank must be removed. You also have to carefully unplug any electrical connectors and some very small and thin EVAP system hoses along with the fuel lines and fuel filler hose. It is best to have a lift for this as well as a fuel tank or transmission lift because when you're putting it back in, you have to stop before it's all of the way up in order to reconnect all of the hoses and connectors, in various order, and in various positions. It's also very important to clean the outside of the tank before removing the fuel pump so that no contaminants reach the inside of the tank. In order to separate hoses from their fittings, I recommend a pick tool to loosen them first before pulling them off and you may need quick disconnect tools for the fuel and evap lines. When putting hoses back on, put some petroleum jelly on the outside of the pipe and inside of the hoses to ease installation. This substance will not harm the rubber or the fuel it comes into contact with. If any of these things seem overwhelming, then take it to a professional repair facility, preferrably one that is a Blue Seal rated one by the National Institute for Automotive Service Excellence. This will ensure that the shop is in the top 3-4% of all shops in the nation. You're more likely to get a better warranty as well as a better quality part. This part is so important that I recommend OE level quality or better since it is so hard to replace again. Also beware of the %26quot;lifetime warranty%26quot; that you may get from a discount part supplier because they will give you a new one every time, but you will have to lower that tank everytime too, and let's not forget about the tow bill and being stranded. Hope this helps you make your decision.
How do I change a fuel pump on a 1999 ford explorer?
I would say get a pro to do it cause its in the tank
Take it to a garage.



I wouldn't mess around with fuel/transmission as a DIY job.