How to change fuel pump 94 ford aspire?

First of all how do i get to it and second what is needed to be done
How to change fuel pump 94 ford aspire?
if your car still runs a little try to get the tank empty or try to syphon some gas out first. This way you don't have to get really high and covered in fuel. Then ......



Relieve the Fuel System Pressure .

best way to do this is disconnect the fuel pump relay and/or fuse and run the car till it stops. Or if you have a fitting on the fuel rail take a screwdriver and push the pin in.( watch out though because fuel will spray out. I usually put a rag over the screwdriver. WITH THE CAR OFF.) But then again if you are replacing your fuel pump you probably don't have any pressure.......



Remove the two rear seat cushion bolts.

Fold the rear seat back cover and cushion forward.

pull the rear seat cushion and cover out from under the rear seat back cover and cushion and remove the rear seat cushion and cover

Remove three luggage compartment floor cover hold-down pins and fold the luggage compartment floor cover forward until the fuel pump assembly access plate is visible.

Remove the four fuel pump access plate screws, the ground lead, and the fuel pump assembly access plate

Disconnect the fuel pump assembly electrical connector.



if you got a 4 door- remove the fuel vapor tube shutoff valve bolt and the evaporative emission tube shut off valve from the bracket on the fuel pump assembly housing.



Loosen the two hose clamps and disconnect the two fuel pump hoses from the fuel pump hose fittings on the fuel pump assembly housing.



Remove the screws and lift the fuel pump assembly housing out



Disconnect the fuel level sensor electrical connector.

Remove the two fuel level sensor washers and fuel level sensor nuts and the fuel level sensor.



Remove the fuel level sensor.

Remove the fuel pump screw, fuel pump grommet and the fuel pump bracket from the bottom of the fuel pump

Remove the fuel tank sender filter bracket, fuel tank sender filter and the fuel tank sender filter retainer from the fuel pump.

Disconnect the fuel pump electrical connector.

Remove the clamp and the fuel pump from the fuel pump assembly housing.



DO the reverse off this to put it back in. I am a certified ford tech and i tried to write some of this from the manual. Basiccally it's not that hard. Just take the seat out and then unbolt the cover from the tank and then take off the fuel hoses. Then take the pump assembly out. Then just dissconect everything to get the stupid pump out.





FOLLOW UP...

It should take about an 1hr to 2hrs depending on your shill level. But you might want to budget more time because it freakin cold outside. Just take your time so you don't mess anything up. Good luck!
How to change fuel pump 94 ford aspire?
So just to get this correct it is as simple as getting the back seat out and then working the fuel pump out? you say your a certified ford tech, so how long should this take? i will be doing this in a driveway and its about -10 F in the mornings and that is when i will be doing it. So if i could get an estimate on time this will take that would be greatly appreciated.